DreamLover @ Fetishcon Jul 28-31 2011

Those of you near Tampa, Florida, will soon have a chance to see the DreamLover 2000 showcased at the prestigious and ever-expanding fetish tradeshow, the Fetishcon.

You will find the DreamLover 2000 at MatureMetal's booth, presented by MatureMetal staff. As many of you know, MatureMetal, makers of quality metallic male chastity devices, have recently created a DreamLover 2000 compatible metallic CB which uses the two (electrically insulated) halves of the CB as electrodes.

This work was pioneered by our trailblazing pilot run member Q, and the same mounting method previously applied on the Watchful Mistress is now being used by MM to enable compatibility with several of their CB models including the popular Jailbird.

DreamLover 2000 compatible MM CBs will soon be available for sale on MM's website (but if you can't wait you can e-mail MatureMetal and they can most likely start building one for you).

*UPDATE*

Mistress Delia and Mistress Layla interview the folks at MatureMetal about their DreamLover 2000 integration attempts on this podcast/interview:

http://www.talkshoe.com/talkshoe/web/talkCast.jsp?masterId=78986&cmd=tc

(Click on the 7/22/2011 podcast; the DreamLover part starts at 5:00, quick registration is required as this is an 18+ podcast...)

Comments

By Billone at 2011-07-29 09:40:42 Reply

*NOTE* [Having just checked with Mature Metal]

The device works ONLY for the plastic tabs.
It does *NOT* work with a metal lock.

(And the price is currently $150 above the cost of the basic cage)

By dreamloverlabs at 2011-07-29 13:06:12 Reply

You can probably put some heat shrink tubing on the lock... or plastidip if you've got that much time :)

By billone at 2011-08-01 10:37:54 Reply

The fit between the lock and the device is *tight*. Possibly you could ream out the holes enough to do this... But by experiment even paint is too thick... so adding a heat shrink isn't possible on an unaltered device.
[In fact, first insert of the lock into the unmodified device require a bit of working it in and out before it wore down enough to be inserted with only a comfortable amount of force.]

I *suspect* that the route I'm going to have to use is to use the entire device (cage and ring) as one electrode, and another electrode against the skin with the backside insulated so it can be inserted into the cage without shorting out.

But clearly there are a lot of things that could be done, so I have no doubt that something workable can be done.

By zippy at 2013-03-26 05:35:01 Reply

Couldn't you just get a smaller lock with a more narrow bolt and a lock protector?